Whirlpool Washer Won'T Start Cycle - Sears Home Services (2024)

FAQs

Whirlpool Washer Won'T Start Cycle - Sears Home Services? ›

The most common reasons your Whirlpool washer won't start cycle are a malfunctioning electronic control board, jammed door lock assembly or a faulty user interface.

Washer needs a reset: Resetting the machine can cycle its power, enabling it to start again. Unplug the washing machine or turn off its power at the circuit breaker. After one minute, restore power and try starting the washer.

Cause 1: Unplugged power source. Cause 2: Overheated machine. Cause 3: Wrong settings. Cause 4: Malfunctioning lid switch.

If your washer is plugged into an outlet, simply unplug the unit for one minute and then plug the unit back in. If the washer is hard-wired to the power supply, turn the breaker off at the home electrical panel that powers the washer for one minute and then turn the breaker back on.

If your washing machine won't start and just clicks, there may be debris in the washer drain. Check the drain to see if there's any debris (particularly large items, like coins) that may be stuck inside.

The most common cause of a Whirlpool washer that is stuck on sensing is a faulty actuator. However, this problem may also be caused by a clogged drain pump, a failed door latch/lid switch, a torn drive belt, a faulty pressure switch, or faulty water inlet valves.

Common problems include Whirlpool washers not starting, making loud noises, displaying error codes, and more. The average life expectancy of a Whirlpool washer is 10 to 15 years depending on type and upkeep, and like other washers that may last as long, you'll need to assess whether it's worth fixing.

Reset your washing machine

What you can do instead is power cycle it: Unplug it (or turn off power at the circuit breaker), wait some time for the electrical charge to clear out of the washer (usually 1 to 5 minutes at most), and then power it up again.

Some washing machines have a reset function, consult your manual for details. Also, reset by disconnecting from power for a few minutes. Open and close the door of the machine 6 times within 12 seconds for a master reset. Before a reset, check power, circuit breaker, child lock, drain house or adjust the load.

Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset. You can run a test load without any clothing to ensure that the reset worked.

Why wont my Whirlpool front load washer start but has power? ›

If you find your Whirlpool front load washer not starting, but has power, the door may not be fully closed and latched. To prevent leaks, front load washers won't begin a cycle unless the door is completely closed. Before closing the door, make sure there are no overhanging clothes that can prevent proper closure.

Washer making Error "Beeps"

Typically this will happen if the washer door has not been opened and closed for at least 3 cycles. This code may appear when the washer is first turned on. Open and close the door to clear the display.

Check the stator windings and rotor magnets of the motor stator assembly for damage and replace as needed. Check for drainage issues such as a clogged drain filter, twisted drain hose or faulty drain pump. These can prevent a washer from spinning. Inspect the motor control board for burned or shorted-out components.